Auto Flying Banner Hoist
The Auto Flying Banner Hoist is a unique product that solves a specific problem; the high cost and invconvenience of changing out banners that are displayed high off the ground. This is very common in shopping malls, airports, theaters, museums, stadiums, arenas, and convention centers, as well as many other locations. These venues have room to display large banners in locations that are difficult to access, so tall ladders or mechanical lifts are needed in order to change the banners. This makes updates time consuming, expensive, and dangerous, and can even discourage banner changes for these reasons.
The Auto Flying Banner Hoist makes all of that a thing of the past. With a simple push button remote control, banners can be lowered up to 70 feet to make changes quick, safe and simple. Raising the banner is just as easy and the banner position can be set by stopping the banner at any point as it raises or lowers.
The Auto Flying Banner Hoist includes a set of 2 piece rectangular aluminum dowels that holds a banner with a pole pocket up to 5' wide. The aluminum dowels are 1/2" wide and 1" tall to securely hold even heavy banners with bending or bowing. The top dowel attaches with thumb screws through metal brackets on either end of the aluminum rail that are spaced 35.5" apart, and is raised and lowered by metal cables in the housing. The aluminum dowels can also be used to connect to banners with other dowels, or even graphics in frames. These other hanging systems can connect to the same metal brackets on the aluminum rail directly for the ultimate in versatility. Banners up to 10' wide can be supported using this method. Optional 2 piece metal dowels are available to hold up to 8' wide banners, and these can be found in the Related Products tab.
The two piece aluminum dowels connect together securly using set screws that hold the two halves together. The bottom dowel acts as a weight in the bottom pole pockets of the banner, and the top dowel has thumb screws that hold the banner to the aluminum rail that is raised and lowered by the hoist.
Both wall and ceiling mounting hardware are included, and the unit comes standard with a 110 volt plug, although hard wiring is also supported and the base unit has a switchable power supply that works with either 110 or 240 volt power sources.
|Is a Featured Product||Yes|
|Free Ground Shipping||N/A|
Auto Flying Banner Hoist Specifications
- Body Dimensions: 34.65" w x 4" d x 4.7" t
- Shipping Dimensions: 40" x 8" x 8"
- Display Weight: 25 lbs
- Shipping Weight: 35 lbs.
- Maximum Banner Weight: 55 lbs
- Cable Length: 72 feet
- Dowel Dimensions: 61" x 1" x 1/2"
- Thumbscrew Spacing: 35.5"
- Electrical Requirements: 110V / 60 Hz with supplied plug. 110V - 240V if hardwired
- Motor Specs: 24V DC / 35 RPM (3A)
- Power Use in Standby: 1 W
- Maximum Power Consumption: 250 W
- Warranty: 1 Year